Response SL5 Manual de instrucciones descargar pdf (Pagina 50)

LATCH KEY

If the Latch Key function is enabled and the

system is disarmed by a user that is enabled for

Latch Key then…

1. The first Latch key phone number will be called

(if entered).

10s after the number is dialled the appropriate

User ID message will be replayed.

The appropriate user ID message will be repeated

continuously for 60s. After 60s has elapsed the

current message play cycle will be completed and

then the call will be terminated. This ensures the

message is not cut off part way through.

There is a 10s delay before the second latch

Key phone number is dialled (if entered).

After both entered numbers have been dialled

once. There will be a 30s delay before the next

call sequence is started again from the first

entered number.

The dialler sequence can be stopped early by either…

a. All numbers have been dialled three times

b. A call is acknowledged by the recipient

pressing the button on the telephone

keypad.

ZONE LOCKOUT

If while the system is armed a single alarm zone

triggers an alarm more than three times and zone

lockout is enable then the particular zone will be

“locked out” and any further alarm signals from that

zone will be ignored by the siren and an alarm will

not be triggered again during that armed session.

The zone lockout will be cancelled when the siren

is disarmed.

If zone lockout is disabled then there is no limit to the

number of alarms that any single zone can initiate.

Zone lockout is applicable to Alarm zones only. It

does not operate with the Fire zone.

DEVICE TAMPER

The Tamper zone operates on a 24 hour basis.

(i.e. Receipt of a Tamper signal form any device

will immediately trigger an alarm irrespective of

systems armed/disarmed status unless the system

is in program or Test modes).

If the battery cover of any device (except a Remote

Control) is removed or if the Siren or Control Panel

are removed from the wall then an alarm will

immediately occur (unless the system is in Test or

Program modes), even if the system is Disarmed.

The Alarm will sound until the set alarm duration time

expires or the system is Disarmed from the Remote

Control or Keypad. The ‘ALARM MEM’ LED on the

Control Panel will flash and the panel will beep every

few seconds to indicate an alarm has occurred.

CHIME

The Chime facility can only be operated with the

system in Standby mode.

Press to toggle the Chime facility between ON

and OFF.

Also see page 39 in Zone Setup menu, 3.7 Znn

Chime to enable the required zone.

KEYBOARD BEEP MUTE

The keyboard beeps can be temporarily switch

on/off by pressing

ENTRY/EXIT BEEPS

If the entry/exit delay beeps are enabled then they

may be temporarily switched OFF during the active

delay period only by pressing

When the next entry/exit delay periods starts the

beeps will follow the main system setting as normal.

EVENT LOG

Any new event entered into the event log will be

indicated by the ‘Alarm Msg’ LED flashing every

5 seconds.

Note: Alarm events only will cause the panel to

beep every 10s, other system events entered into

the event log (e.g. low battery) will not initiate the

warning beeps.

Message replay

starts

Message play time

expires

10s

60s Message Play Time

Dialler delay expires

number called

Message replay complete

Call ended and line hung up

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 63 64

Comentarios a estos manuales

Sin comentarios

Response SL5 Manual de instrucciones Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5