Response SL5 Manual de instrucciones descargar pdf (Pagina 33)

VOICE DIALLER SETUP MENU

Phone Numbers

Record Alarm Messages

Replay Alarm Messages

SPECTRA LIGHTING SETUP

Set Light-On Period

Spectra Mode

Stop Time

Start Time

TELEPHONE APPLICATION SETUP

If using any of the telephone based functions,

(e.g. Answer Phone, Voice Dialler, Remote Phone

Access and Control etc.) the Dial Method must

be set as follows:

Remote Manager

1) set Dialler Mode = “Remote

Manager”

2) set Remote Manager Phone

Numbers

3) set System ID Code

Voice Dialler

1) set Dialler Mode = “Voice Dialler”

2) set Voice Dialler Phone Numbers

3) set Dial Sequence

4) record Alarm Messages

Answer Phone

1) set Rings to Answer Phone

Latch Key

1) set Latch Key Status =

“ON” or “OFF”

2) enable users if “ON” chosen

3) set Latch Key Phone Numbers

4) record User ID Message(s)

USER SETUP

This menu allows the 4 digit User Access Codes

to be configured for each user. The general users

(1- 6) may also record a 4 second message to be

used with the Latch Key feature in the Latch Key

Setup menu.

Scroll through the top level programming menu until

‘1. USER SETUP’ is displayed and press .

Note: After configuring all required users, press

to return to the top level of programming menu.

MASTER USER

Default setting: 1234

Scroll through the menu until ‘1.0 Master User

Code:’ and the current access code is displayed.

To change the access code press .

Enter the new 4 digit User Access Code which

will be displayed on the LCD.

Press to save new setting and exit, or

Press to exit without saving.

Note: User must enter a 4 digit code, 1,2 or 3

digit codes are not acceptable.

USERS 1-6 and DURESS CODES:

To change User 1 access code, select ‘1.1 User 1 Code’