Response SL5 Manual de instrucciones descargar pdf (Pagina 20)

6. Activate the Tamper Switch on the MAG

detector.

If the detector is new and not already linked on

any security zone the panel will produce two

short beeps and the display will show ‘New

Device’ and the type of device detected (MAG).

7. Confirm the new device ID code by activating

the Tamper Switch on the same new MAG

detector within 15 seconds.

The panel will produce three short beeps and

the LCD will show ‘Device Confirmed’.

The LCD will then show ‘Saving New Device’

while the ID code of the new detector is stored

into memory.

8. Refit the battery cover.

9. After completing the Zone Setup press to

return to the top level of programming menu.

TESTING A MAGNETIC DOOR/WINDOW

DETECTOR WITH THE CONTROL PANEL

1. Ensure that the system is in Test Mode (see

page 13).

Use the and buttons to scroll through

the menu until ‘Detector Walk Test’ is displayed

and press .

will be displayed.

Note: If no signal is received by the Control Panel

within 10 minutes, the display will return to ‘Detector

Walk Test’

Open the door/window to remove the Magnet

from the Detector.

In addition, the Control Panel will beep to

indicate that the alarm signal has been received

and the identity of the zone that the detector is

configured for will be displayed.

Remove the battery cover. The Control Panel

should beep and display:

to show that the detector’s tamper switch has

been activated.

Refit the battery cover.

Press to exit Test Mode and return to

standby.

IMPORTANT: With the battery cover fitted the

LED indicator will not flash when the door / window

is opened, (unless the battery is low).

Note: If the detector is already linked to the

control panel on any other zone then the

panel will produce a single long beep and

the received signal from the detector will

be ignored.

Note: If the confirmation signal is not

received within 15s the control panel will

produce a single long beep and exit the

learning process. The learning process will

need to be started again to learn the new

device into memory.

ESC

ENTER

Walktest

Waiting...

Zone X : MAG

Tamper

ESC

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Comentarios a estos manuales

Sin comentarios

Response SL5 Manual de instrucciones Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5