Response SL5 Manual de instrucciones descargar pdf (Pagina 10)

CONFIGURING THE REMOTE CONTROL

1. Remove the rear cover by undoing the small

screw on the rear of the Remote Control and

keeping it safe for later.

2. Insert the battery under the clip ensuring that

the

terminal faces upwards away from the

Circuit Board.

3. Replace the rear cover and fixing screw. Do not

over tighten the screw as this could damage the

thread.

TESTING THE REMOTE CONTROL

4. Press the button. The Transmit LED

should illuminate while the button is pressed and

extinguish within 1 second of releasing the button.

5. Pressing any button on the Remote Control will

illuminate the Transmit LED as before to check

that it is functioning correctly.

CONTROL PANEL

POSITIONING THE CONTROL PANEL

When choosing a suitable location for the Control

Panel, the following points should be considered.

1. The Control Panel should be located in a

position out of sight of potential intruders and in

a safe location, but easily accessible for system

operation and leaving and entering the house

within the set time period.

2. The Control Panel should be mounted on a sound

flat surface to ensure that the rear tamper switch

on the Control Panel is closed when the Panel is

mounted. The Control Panel should be mounted

at a convenient height of between 1.5 and

2 metres and in a position where it will be seen

each day.

Note: If small children are in the household, a

further consideration should be given to keeping

the unit out of their reach.

3. It is recommended that the Control Panel should

be positioned such that the Exit/Entry tone

(emitted by the Control Panel) can be heard from

outside the property.

4. The Control Panel should be mounted within a

protected area so that any intruder cannot reach

the Control Panel without opening a protected

door or passing through an area protected by a

PIR Detector when the system is armed.

5. The Control Panel must be located within

reach of a mains socket.

6. If any of the telephone based functions are to be

used then the Control Panel will need connecting

to a convenient telephone point.

ENTER

ESC

POWER ALARM

STATUS

ALARM MEM/

MESSAGE

LINE

STATUS

2 3

LCD

Display

Window

Status

Indicator

LEDs

Keypad

Battery Clip

Battery

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comentarios a estos manuales

Sin comentarios

Response SL5 Manual de instrucciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5