Response SL5 Manual de instrucciones descargar pdf (Pagina 41)

NAME

This enables a name to be allocated to the zone so it

can be identified by its location.

Available for all zones 1- 36. Only available for

wireless zones 1-32 if a detector is linked.

Default setting: No Name

Scroll through the Zone menu until ‘3.2 Zxx Name’

(and the current setting) is displayed.

To change the setting press .

Scroll through the menu options, until the

required setting is displayed.

Options: No name, Front Door, Back Door,

Side Door, Patio Door, Dining Room,

Living Room, Lounge, Study,

Play Room, Kitchen, Utility Room, Hall,

Landing, Bedroom 1, Bedroom 2,

Bedroom 3, Bedroom 4, Bedroom 5,

Shed, Garage, PIR, MAG or SMOKE.

Press to save the new setting, or

Press to exit without saving.

TYPE

Each zone may be programmed to operate in 1 of 4

different modes dependant upon the type of alarm

function required. The following types are available:

Intruder - provides standard intruder monitoring.

24 Hour Intruder - used to provide 24 hour

monitoring of areas requiring continuous security

protection even while the system is Disarmed, (e.g.

gun lockers). Activation of any detector on a

security zone will immediately initiate an Alarm.

Fire - used to provide 24 hour monitoring of any

Fire/Smoke detectors fitted to the system. Activation

of any detector will immediately initiate an Alarm.

Test - when the system is armed, any detector on

the zone will generate an entry in the Event Log

without initiating an alarm.

Default setting: Intruder

Scroll through the Zone menu until ‘3.3 Zxx Type’

(and the current setting) is displayed.

To change the setting press .

Scroll through the menu options, until the

required setting is displayed.

Press to save new setting and exit, or

Press to exit without saving.

ZONE MODE

Each zone may be selected to operate with or

without a entry/exit delay period (see System Setup

menu). This is selected in zone mode.

Default setting: Zones 1- 2: Delayed

Zones 3-36: Instant

Available for all zones 1- 36. Only available for

wireless zones 1-32 if a detector is linked

Scroll through the Zone menu until ‘3.4 Zxx Mode’

(and the current setting) is displayed.

To change the setting press .

Scroll through the menu options, until the

required setting is displayed.

Options: Instant / Delayed

Notes: Smoke detectors can only be

set as Instant

Press to save new setting, or

Press to exit without saving.

PART-ARM 1

This controls whether the zone is active when

Part-Arm 1 is armed.

Default setting: Zones 1- 4: ON

Zones 5-36: OFF

Scroll through the Zone menu until ‘3.5 Zxx Part-Arm 1’

(and the current setting) is displayed.

To change the setting press .

Press to enable the zone in part arm 1, or

Press to disable the zone in part arm 1.

ENTER

ESC

ENTER

ESC

ENTER

ESC

ENTER

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Comentarios a estos manuales

Sin comentarios

Response SL5 Manual de instrucciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5