Response SL5 Instrucciones de operaciones descargar pdf (Pagina 41)

b) Press

, ,

on the Control Panel.

DISARM

The system can be Disarmed using either the Remote

Control or the Control Panel as follows:

a) Press on the Remote Control, or

b) Press

, ,

on the Control Panel.

If when the system is disarmed the ‘ALARM MEM’ LED

is flashing and the panel beeps every 10s, this indicates

that an alarm condition has occurred. Inspect the

Event Log to find out the type of the alarm and to assist

in tracing the cause of the alarm or alternatively.

Press to clear the LED and stop the beeping.

Note:

If the system is Disarmed with the Remote

Control the Siren will beep twice, (unless the

warning beeps have been disabled on the Siren).

QUICK SET

The Quick Set function fully arms the system with a 5s

exit delay:-

Press , ,

Alternatively, pressing during the exit-delay

period of any armed mode (including Part-Arm 1 and

Part-Arm 2) will reset the remaining exit-delay period

to 5s.

OMIT ZONE

To temporarily omit a zone and disable it during the

next armed session:-

Press , ,

Scroll through the menu to select the required zone.

The current zone setting will be displayed.

To change the setting press .

Press to omit the zone,

(i.e. zone omit = ON).

Press re-enable the zone,

(i.e. zone omit = OFF).

After configuring zones to be ommited as required

press to return to Standby mode.

Note: Omitting a zone will only affect the next armed

session. When the system is disarmed the omitted zones

will be re-enabled ready for the next armed session.

PERSONAL ATTACK (PA) ALARM

A full Alarm condition can be immediately initiated at

any time (whether the system is Armed or Disarmed) in

the event of threat or danger by activating a Personal

Attack (PA) switch on either the Remote Control or the

Control Panel as follows:

a) Slide the Personal Attack switch on the Remote

Control upwards, or

Press and hold the button for

approximately 3 seconds on the Control Panel.

The alarm will continue either for the alarm duration

when the system will automatically reset or until the

system is disarmed.

TAMPER

If the battery cover of any device (except a Remote

Control) is removed or if the Siren or Control Panel are

removed from the wall then a Full Alarm condition will

be initiated even if the system is Disarmed. The alarm

condition will continue either for the alarm duration

when the system will automatically reset or until the

system is Disarmed. The ‘ALARM MEM’ LED on the

Control Panel will flash and the panel will beep every

few seconds to indicate an alarm has occurred.

Note:

The Tamper protection facility on the Siren

operates independently of the Control Panel. If the

Tamper on the Siren is activated this will not be

indicated at the Control Panel.

CHIME

The Chime facility can only be operated with the

system in Standby mode.

Press to toggle the Chime facility between ON

and OFF.

OPERATION

SA5

? ? ? ?

ENTER

User Access Code

? ? ? ?

ENTER

User Access Code

? ? ? ?

ENTER

User Access Code

ESC

? ? ? ?

ENTER

User Access Code

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Comentarios a estos manuales

Sin comentarios

Response SL5 Instrucciones de operaciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5