Response SL5 Instrucciones de operaciones descargar pdf (Pagina 27)

PROGRAMMING

SA5 25

Replay User Latch-Key Message

Scroll through the menu until ‘:3 Replay User

Message’ is displayed and press to replay

the message.

Press to return to the top level User-Setup

menu.

MASTER USER

Default Access Code: 1234

Scroll through menu until ‘1-7 MASTER USER

SETUP’ is displayed and press .

Scroll through the menu until ‘:1 Access Code’ (and

the current setting) is displayed.

To change the setting press .

Type in a new 4 digit Access Code, and then

Press to start the voice recorder

Press to return to the top level User-Setup

menu.

Scroll through the top level programming menu

until

‘2. SYSTEM SETUP’ is displayed and press

Note: After completing the system setup press

to return to the top level programming menu.

LEARN SYSTEM HOUSE CODE

Scroll through the menu until ‘2-1 Learn House Code’

is displayed.

To change the setting press .

The current House code setting will be displayed.

The new system House Code can be programmed

either directly at the Control Panel or via a Remote

Control Unit.

At the Control Panel

Press buttons 1-8 on the Control Panel to

configure the display to the correct house

code setting. As each button is pressed the

corresponding digit in the code will change to

the opposite state, (“0” or “1”).

1=House Code DIP Switch On/Up

0=House Code DIP Switch Off/Down

SYSTEM SETUP

The parameters in this menu allow the configuration of the general system parameters, such as the control panel

house code, alarm duration and control of any hardwired or output relay alarm contacts. This section also contains

the basic setup information for the systems telephone dialler interface which must be configured appropriately if

any of the telephone based functionality is to be used.

2. SYSTEM SETUP

2-5 Back Light

xxs

2-7 Zone Lockout

xxx

2-9 Rings to

Answer Phone: xx

2-11 Dial Method

xxxxxxxxx

2-3 Wirefree

Siren: xxx

Press DISARM on

Remote...

2-1 Learn House

Code

10s

20s

30s

60s

Select

ON->1 OFF->3

select menu item

…press ENTER

2-2 ALARM TIME

xxx : xxxs

2-4 RF Jamming

Detection: xxx

Select

ON->1 OFF->3

2-2-1 Status

xxx

Select

ON->1 OFF->3

2-2-2 Time

Enter 1-60(x10)s

30s

60s

180s

300s

ON until Disarm

select menu item

…press ENTER

2-6 Alarm Relay

xxxxxxxxxxxxxx

Select

ON->1 OFF->3

2-8 Remote Phone

Control: xxx

Select

ON->1 OFF->3

2-10 Dial Delay

xxx

Select

ON->1 OFF->3

Enter 1-30: Tone/DTMF

Pulse

2-12 Dialler Mode

xxxxxxxxxxxxxx

Voice Dialler

Remote Manager

select menu item

…press ENTER

select menu item

…press ENTER

PROGRAM MODE

CODE:

ENTER

ESC

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Comentarios a estos manuales

Sin comentarios

Response SL5 Instrucciones de operaciones Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5