Response SL5 Instrucciones de operaciones descargar pdf (Pagina 34)

PROGRAMMING

32 SA5

To change the setting press .

Scroll through the menu until the required ‘Phone

No._’ (and the current setting) is displayed.

To change the setting press .

Press to enable the phone number, or

Press to disable the phone number.

Press to return to the top level Voice Dialler

Setup menu.

TEL CONFIRM TIMES

This sets the number of acknowledged phone numbers

required to stop the voice dialler. (For example, if set to

"2" then the dialler sequence will continue until an

acknowledgment signal is received from two different

numbers.

Default setting: 1

Scroll through the menu until ‘4-6 Tel Confirm Times’

(and the current setting) is displayed.

To change the setting press .

Enter the required number of confirmations (1-4).

Press to save and exit, or

Press to exit without saving.

CALL ATTEMPTS

This sets the maximum number of times that the dialler

will attempt to contact each enabled telephone number

in the call routing sequence.

Default setting: 3

Scroll through the menu until ‘4-7 Call Attempts’ (and

the current setting) is displayed.

To change the setting press .

Enter the required number of dial attempts (1-5).

Press to save and exit, or

Press to exit without saving.

FULL ARM SETUP

The parameters in this menu control over the systems

exit-delay period and the exit/entry delay warning

beeps during Full Arm mode.

Scroll through the programming menu until ‘5. FULL

ARM SETUP’ is displayed and press .

Note: After configuring Full Arm press to return

to the top level programming menu.

EXIT-DELAY PERIOD

Scroll through the menu until ‘5-1 EXIT-DELAY’ (and

the current setting) is displayed

To change the settings press .

On/Off Status

Default setting: ON

Scroll through the menu until ‘5-1-1 Status’ (and

the current setting) is displayed.

To change the setting press .

Press to enable the exit-delay, or

Press to disable the exit-delay.

Delay Period

Default setting: 30s

Scroll through the menu until ‘5-1-2 Delay Time’

(and the current setting) is displayed.

To change the settings press .

Enter the required delay period (10 to 250s).

Press to save and exit, or

Press to exit without saving.

Press to return to top level Full Arm Setup

menu.

5. FULL ARM

SETUP

PROGRAM MODE

Code:

5-3 Exit Delay

Beep: xxx

5-2 Entry Delay

Beep: xxx

Select

ON->1 OFF->3

Select

ON->1 OFF->3

5-1 EXIT Delay

xxx xxxs

5-1-1 Status

xxx

Select

ON->1 OFF->3

5-1-2 Delay Time

Enter (10-250s)

ESC

ENTER

ESC

ENTER

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Comentarios a estos manuales

Sin comentarios

Response SL5 Instrucciones de operaciones Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL5