Response SA1 E PLUS Instrucciones de operaciones descargar pdf (Pagina 19)

When leaving the premises, the system must be

Armed. However, before doing so, check that all

windows are closed and locked, all protected doors

are closed and PIR Detectors are not obstructed.

Ensure that pets are restricted to areas not

protected by PIR Detectors.

The system has 2 armed modes, Instant-Arm and

Delay-Arm.

Instant-Arm mode will immediately Arm the system.

Once the system is Armed, activating any detector

(i.e. Opening a door/windows protected by a

Magnetic Contact Detector or moving into a PIR

protected area), will immediately trigger an Alarm.

On returning to and entering the property the system

must be Disarmed before opening any protected

door or entering an area protected by a PIR Detector

otherwise an Alarm will occur. For this reason when

using Instant-Arm mode, the system should be

Armed and Disarmed from outside the property using

the Remote Control.

Delay-Arm mode will Arm the system with a 15

second entry/exit delay. On arming the system in

Delay-Mode the siren will beep once and then again

after the 15 second delay has expired. This allows

time for you to leave the property before the system

becomes fully Armed. On returning to and entering

the property by opening a protected door or moving

through a PIR protected area the system will be

triggered and the Siren will emit a single long beep.

However, an Alarm will not sound until the 15

second delay has expired. The system must be

Disarmed using either the Remote Control or

Remote Keypad during the 15 second delay to

prevent the Alarm from sounding.

If an Alarm occurs the Siren will sound continuously

until the set alarm duration time expires. The alarm

will then stop and the system will automatically

re-arm itself. This process can be repeated up to

3 times after which time the ‘Alarm Lockout’ feature

will operate and prevent the system from re-arming.

Notes: To conserve power and maximise battery

life the PIR Detector will only detect movement if

there has been no movement detected within the

previous 2 minutes.

Arming the System

ARM

The system can be set in ARM mode using either the

Remote Control or the Remote Keypad as follows:

Remote Control:

ress the button.

The Siren will acknowledge the signal by beeping

once.

Remote Keypad:

Press:

The Siren will acknowledge the signal by beeping

once.

DELAY-ARM

The system can be set in delay-arm mode using either

the Remote Control or the Remote Keypad as follows:

Remote Control:

Press the button.

The Siren will acknowledge the signal by beeping

once and then again after the 15 second entry/exit

period has expired. The system will not be fully

Armed and active until after the second beep.

Remote Keypad:

Press:

The Siren will acknowledge the signal by beeping

once and then again after the 15 second entry/exit

period has expired. The system will not be fully

Armed and active until after the second beep.

Operating Instructions

User Access Code

? ? ? ?

, or

User Access Code

? ? ? ?

1 2

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comentarios a estos manuales

Sin comentarios

Response SA1 E PLUS Instrucciones de operaciones Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA1 E PLUS