Response SA1 E PLUS Instrucciones de operaciones descargar pdf (Pagina 15)

Siren Housing

The Siren, Strobe Light and Solar Panel are all

encapsulated within a tough polycarbonate housing.

This housing provides full protection against adverse

weather conditions. All electronic components are

specially treated to ensure long, reliable, trouble free

operation and an integral tamper switch gives

maximum security protection to the unit.

An LED indicator unit is built into the Siren to act as

a visible deterrent and indication that the system is

active. The LEDs will slowly and alternately flash

whether the system is Armed or Disarmed. When

an alarm occurs the LEDs will flash rapidly together.

An integral tamper switch provides additional

security protection to the Siren and will immediately

trigger an alarm should any unauthorised attempt

be made to interfere with and remove the Siren

cover, (unless the Siren is in Service Mode).

Rechargeable Battery

The Solar Siren is powered by a high capacity

battery. A Solar Panel mounted on the top of the

housing charges the battery during daylight hours.

During darkness, only a small amount of energy is

required to operate the Solar Siren unit.

Initial Power-Up Battery

An Alkaline 9V PP3 battery is supplied in the Siren &

Strobe unit to provide the initial power to the system.

Siren Code

An encrypted code is set using a combination of

miniature switches. This enables you to select a

unique security code for your installation.

Choosing a Location for the

Solar Siren

The Siren & Strobe unit should be fitted to the outside

of the building in a position that is clearly visible and at

a height which is relatively inaccessible to an intruder.

Although the Siren & Strobe is designed to work on

any aspect wall, you should refrain from fixing the

unit on a North facing wall where possible.

Shadows cast by neighbouring walls, trees and roof

overhangs should also be avoided. In practice, the

Siren & Strobe should be positioned a minimum of

twice the width of the eaves overhang, below the eaves.

Remember that in winter the sun is lower in the sky

and you should avoid winter shadows where possible.

The Siren & Strobe contains a sophisticated radio

receiver. However, reception of radio signals can be

affected by the presence of metallic objects within

the vicinity of the Siren & Strobe. It is therefore

important to mount the Siren & Strobe a minimum

distance of 1 metre radius away from any external

or internal metalwork, ie external drainpipes, gutters

and internal radiators, mirrors etc.

Installing the

Solar Siren

Remove the holding screw from the base of the housing

and carefully hinge off the front cover. All electronic

components are housed within the front cover.

Use the rear back-plate as a template to mark the

position of the four fixing holes on the external wall.

Drill four 6mm holes and insert the plastic wall plugs.

Mount the back-plate using the four screws provided.

External Solar Siren

Avoid if

possible

South

West

East

North

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comentarios a estos manuales

Sin comentarios

Response SA1 E PLUS Instrucciones de operaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA1 E PLUS