Response SA1 E PLUS Instrucciones de operaciones descargar pdf (Pagina 18)

Testing an Installed System

The system should be tested at regular intervals (at least

every 3 months) to ensure that it is operating correctly.

1. Before commencing testing please ensure the

following:

−

The Siren is in Operating Mode and Disarmed

− There is no movement or people/pets in any

PIR protected area

− All doors/windows protected by Magnetic

Contact Detectors are closed

− All battery covers and housings are correctly

fitted

Remote Control:

2. Press the button on the Remote Control.

The Siren will beep once.

3. Activate the PA switch on the Remote Control

by sliding it upward.

The alarm will sound.

4. Stop the alarm by pressing the button

on the Remote Control.

The Siren will stop and acknowledge the signal

by beeping twice (unless Beep Disable has

been selected).

If your system includes a Remote Keypad:

5. Arm the system at the Remote Keypad by entering

your User Access Code followed by the ‘INSTANT-

ARM’ button.

6. Press and hold both ‘DELAY-ARM’ buttons on

the Remote Keypad for approx. 3 seconds,

and the alarm will sound.

7. Stop the alarm and Disarm the system by

entering your User Access Code followed by the

DISARM button on the Remote Keypad.

If your system includes PIR Detectors:

. Arm the system in Instant-Arm mode by pressing

n the Remote Control.

he Siren will acknowledge the signal by beeping

nce, (unless Beep Disable has been selected).

. Ensure that the area protected by the PIR has

een free from movement for at least 2 minutes

and then walk into the area to trigger the

detector.

Note: To conserve power the PIR will only

detect movement if there has been no

movement detected within the previous 2

minutes.

10. Stop the alarm and Disarm the system by

pressing on the Remote Control.

The Siren will stop and acknowledge the signal by

beeping twice, (unless Beep Disable has been

selected).

11. Continue to test all PIR Detectors in turn as

described above (steps 8 - 10).

If your system includes Magnetic

Contact Detectors:

12. Arm the system in Instant-Arm mode by pressing

the button on the Remote Control.

13. Open a door/window protected by a Magnetic

Contact Detector and ensure that the alarm

sounds.

14. Disarm the system and stop the Siren by pressing

the button on the Remote Control.

15. Test each Magnetic Contact Detector in turn as

described above (steps 12 - 14.

Testing the System

User Access Code

? ? ? ?

User Access Code

? ? ? ?

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comentarios a estos manuales

Sin comentarios

Response SA1 E PLUS Instrucciones de operaciones Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA1 E PLUS