
2
FOREWORD
All devices in these wirefree alarm systems are
designed and manufactured to provide a high standard
of security protection and long, reliable service.
These systems are designed for ease of installation
using only basic DIY tools. However, it is essential that
the installer reads and fully understands the advice
and procedures contained in this manual and plans the
system before proceeding with the installation.
No radio operating licence is required for this
equipment.
During installation, it is important that the procedures
described in this manual are followed in sequence.
Note: This manual covers the installation and operation
of a number of different kit congurations. Instructions
relating to devices not included in your kit should be
ignored.
This manual should be retained in a safe place for
future reference.
IMPORTANT: All devices, with the exception of
the External Siren are suitable for mounting in dry
interior locations only.
DECLARATION
Novar ED&S hereby declares that these wirefree
alarm systems are in compliance with the essential
requirements and other relevant provisions of the Radio
and Telecommunications Terminal Equipment (R&TTE)
directive, 1999/5/EC.
Tools and Equipment Required:
No.0 Philips Screwdriver 3mm Drill Bit
No.1 Philips Screwdriver Drill
No.2 Philips Screwdriver Small Spirit Level
5 & 6mm Masonry Drill Bits Bradawl
DEVICE RANGE
The quoted range of the system devices (see
component specication on rear cover) is measured in
ideal conditions. Any solid object (e.g. walls, ceilings,
PVC doors etc.) placed between the transmitter and
Siren will reduce the transmission range of the devices.
The amount by which the range will be reduced is
dependant upon the nature of the barrier. e.g.
Wall Type Range Reduction
Dry-lined partition wall: 10-30%
Single layer brick wall: 20-40%
Double layer brick wall: 30-70%
Metal panel/radiator: 90-100%
Note: The effect on the range of multiple walls is
cumulative. e.g. if there are two brick walls in the way,
the range will be reduced by up to 40% by each wall.
SYSTEM SECURITY
This system has been designed to both detect intruders
and act as a strong deterrent to would-be intruders
when installed correctly.
Please remember that given adequate knowledge and
time it is possible to overcome any alarm system and
we therefore recommend that your alarm system is
used in conjunction with good physical protection such
as security window and door locks.
All units in the system are encoded to operate together
using an 8 bit House Code which is congured by the
user/installer to provide the identication code for your
installation. The system House Code can be changed
at any time by the user.
The system is operated from one or more Remote
Control Units and/or Keypads. Care should be taken
to ensure that any of your Remote Control Units are
not lost and that the Keypad User Access Code and
system House Code do not become known to other
people, as this will compromise the security of your
system. In either event the system House Code and/
or User Access Code should be changed as soon as
possible.
IMPORTANT: All devices in your system must
be set to the same House Code which must be
changed from the factory supplied setting.
SAFETY
Always follow the manufacturers advice when using
power tools; steps, ladders etc. and wear suitable
protective equipment (e.g. safety goggles) when drilling
holes etc.
Before drilling holes in walls, check for hidden
electricity cables and water pipes, the use of a cable/
pipe locater maybe advisable if in doubt. When using
ladders, ensure that they are positioned on a rm
stable surface at the correct angle and suitably secured
before use.
The use of ear defenders is advisable when working in
close proximity to the Siren due to the high sound level
produced by this device.
Comentarios a estos manuales