Response SA1 E Instrucciones de operaciones descargar pdf (Pagina 13)

4. If an additional wired Magnetic Contact is required,

this should be wired to the terminal block provided in

the battery compartment. The wired contact should be

connected using a maximum length of 1.5 metres of

any of the following:

- 6 core alarm cable

- 2 core bell wire (6 x 0.2mm minimum)

- 2 core 24AWG wire

A cable entry cut-out is provided beside the terminal

block in the battery cover.

If an additional wired contact is connected to the

detector then jumper Link S2 on the Circuit board must

be removed.

IMPORTANT: If an additional wired contact is not

connected, then the Jumper Link S2 must be tted

for the Detector to operate correctly.

5. Congure the House Code for the Magnetic Contact

Detector by setting DIP switches 1-8 to the same ON/

OFF combination as the House Code DIP switches in

all other system devices.

7. Slide the two batteries supplied into the battery

holder, ensuring that the + side is uppermost on each

battery as it is installed.

8. If necessary, ret the battery holder into the Detector

ensuring that the spring clip connectors slide onto

either side of the circuit board.

9. Ret the battery cover.

Testing the Magnetic Contact Detector:

10. Remove battery cover to activate the tamper switch.

As the button is released the LED indicator will

illuminate for approximately 1 second to show that the

tamper switch has been triggered and a signal is being

transmitted.

11. Open the door/window to remove the Magnet from

the Detector.

As the Magnet is moved away from the Detector the

LED indicator will illuminate for approximately 1 second

to show that the Detector has been triggered and a

signal is being transmitted.

Note: It does not matter if the LED indicator illuminates

as the magnet is brought towards the detector.

12. Ret the battery cover.

EXTERNAL SOLAR SIREN

The Siren is encapsulated within a tough polycarbonate

housing that also provides full protection against

adverse weather conditions.

An LED indicator unit is built into the Siren to act as

a visible deterrent and indication that the system is

active. The LEDs will slowly and alternately ash

whether the system is Armed or Disarmed. When the

alarm triggers the LEDs will ash rapidly together.

An integral tamper switch provides additional security

protection to the Siren and will immediately trigger an

alarm should any unauthorised attempt be made to

interfere with and remove the siren cover, (unless the

Siren is in Service Mode).













































2 3 4 5 6 7 8 9 10 11 12

















6. DIP Switches 9-11 must be set as follows for use

with this alarm system:

DIP 9 DIP 10 DIP 11

ON ON OFF

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios

Response SA1 E Instrucciones de operaciones Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA1 E