Response SA1 E Instrucciones de operaciones descargar pdf (Pagina 16)

2. Press the tamper switch, both indicator LEDs

will ash together several times. The LED’s will

then continue to ash alternately every 10 seconds

thereafter to indicate that the Siren is functioning.

3. Hinge the front cover locating tabs over the top

edge of the back plate and carefully push the base of

the Siren cover into place. Secure the Siren cover in

place by retting the xing screw in the bottom edge of

the cover. Do not over tighten the screw as this could

damage the thread.

IMPORTANT: Ensure that the rear tamper switch

is closed when you t the Siren cover to the back-

plate (i.e. listen for the switch to click). If the

switch does not close it will prevent the Siren from

operating correctly. If necessary, remove the Siren

cover again and adjust the screw on the back-plate

tamper plunger to ensure the switch closes when

the Siren is secured in position – pressed fully

against the wall.

4. If tted, remove the protective lm covering the Solar

Panel.

IMPORTANT: The Siren must now be left in

position for at least 24 hours to fully charge the

Main Battery before testing or operating the

alarm.

Note: The Siren is automatically in Service Mode and

must be switched into Operating Mode before the

system can be operated or fully tested.

Switch the Siren into Operating Mode using the

Remote Control or Keypad as follows:

Remote Control:

Press and hold the button for 6 seconds.

Keypad:

Enter the User Access Code, then press and hold the

Arm button for 6 seconds:

After 6 seconds the Siren will produce a single long

beep to indicate that it has switched into Operating

Mode in a Disarmed state. The Arm button should be

released during or immediately after the long beep,

otherwise the system will Arm.

TESTING THE SYSTEM

The system should be tested at regular intervals (at

least every 3 months), to ensure that it is operating

correctly.

1. Before commencing testing please ensure the

following:

- The Siren is in Operating Mode and Disarmed.

- There is no movement or people/pets in any PIR

protected area.

- All doors/windows protected by Magnetic Contact

Detectors are closed.

- All battery covers and housings are correctly tted.

If your system includes a Remote Control:

2. Press on the Remote Control

The Siren will beep once.

3. Activate the PA switch on the Remote Control by

sliding it forward.

The alarm will sound.

4. Stop the alarm by pressing on the Remote

Control.

The Siren will stop and acknowledge the signal

by beeping twice, (unless Beep Disable has been

selected).

If your system includes a Keypad:

5. Arm the system at the Keypad by entering your User

Access Code followed by the ‘INSTANT-ARM’ button.

6. Press and hold both ‘DELAY-ARM’ buttons on the

Keypad for approximately 3 seconds.

and .

7. Stop the alarm and Disarm the system by entering

your User Access Code followed by the DISARM button

on the Keypad.

The alarm will sound.

? ? ? ?

User Access Code

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Response SA1 E Instrucciones de operaciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA1 E