Response RE3000S Instrucciones de operaciones descargar pdf (Pagina 15)

5. Hold the Contact Detector at the correct position

on the door or window, then press and release the

anti-tamper switch. Providing the Detector is

within radio range of the Control Unit, the two-tone

chime will be repeated, for another 3 seconds.

When fitting the detector to a metal door or

window, under exceptional circumstances, it

may be necessary to space the Magnet/

Detector off the metal surface using a plastic

or wooden spacer to achieve the necessary

radio range.

6. Remove the battery, then using the double

sided tape OR the screws provided, mount the

magnet to the door and the Detector to the

door frame (or vice-versa, if required). Ensure

that the arrow on the Magnet lines up with the

line on the Detector and that the gap between

the Detector and the Magnet is less than 5mm.

When using the screws for mounting the

Detector, ensure that the small countersunk

screw is used within the battery compartment

and that the screw is driven flush with the

inside of the casing.

7. Refit the battery and battery cover. (The two-

tone chime sound will be repeated at the

Control Unit).

8. Test the operation by opening and closing the

door/window. The red LED on the Detector will

illuminate for approximately 1 second and the

Control Unit will emit a two-tone chime each

time the detector is ‘opened’ and ‘closed’.

Note: In addition to the Standard RE5000M Magnetic

Detector, the RE5000MHW Detector is available and

incorporates facilities to accept hard-wired normally

closed and normally open circuit inputs, in addition to

the standard Contact Detector operation. Refer to

page 27 for further details.

Once you have completed installing all your

Detectors, take the Control Unit out of Test mode

by pressing and holding the button until the

Control Unit emits 2 bleeps and the Arm/Disarm

LED’s extinguish.

INSTALLING AND

SETTING THE EXTERNAL

SOLAR WIRELESS SIREN

& STROBE

The Solar Siren & Strobe Unit should be fitted to the

outside of the building in a position that is clearly

visible and at a height which is relatively

inaccessible to an intruder.

The Solar Siren & Strobe incorporates a solar panel

which will maintain a charge to the integral 6V 1.2Ahr

sealed lead acid rechargeable battery during daylight

hours. During the night a negligible amount of energy

is released by the rechargeable battery to operate the

Siren & Strobe. The Solar Siren & Strobe is self-

maintainable during darkness and long winter periods.

LOCATION

To provide the optimum amount on daylight to the

Solar Panel, you should ideally mount the Solar

Siren & Strobe on a south facing wall. However, an

easterly or westerly position will suffice.

Although the Solar Siren & Strobe is designed to work

on any aspect wall, for optimum performance you

should refrain from siting the unit on a north facing wall

where possible. Shadows cast by neighbouring walls,

trees and roof overhangs should also be avoided.

Where applicable, the Solar Siren & Strobe should be

positioned a minimum of twice the width of the eaves

overhang below the eaves. Remember that in winter

the sun is lower in the sky and you should avoid winter

shadows where possible.

RE5000S Professional Alarm System 13

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Comentarios a estos manuales

Sin comentarios

Response RE3000S Instrucciones de operaciones Pagina 15

Comentarios a estos manuales