Response SL8 Manual de instrucciones descargar pdf (Pagina 8)

REMOTE CONTROL UNIT

The Remote Control Unit(s) is used to Arm in either

Arm or Part Arm modes and to Disarm the system.

The Remote Control Unit also incorporates a Personal

Attack (PA) button. Pressing and holding the

PA button

for 3 seconds will immediately trigger an Alarm

(unless the Control Panel is in Test or Program Modes)

even if the system is disarmed. The alarm can be

cancelled using the Remote Control by pressing the

’DISARM’ button.

Up to a total of 6 Remote Controls and/or Keypad Units

can be used with your system, providing they are all

operated within effective radio range of the Control Unit.

The Remote Control is powered by a CR2032 type

Lithium cell which under normal conditions will have an

expected life of approximately 1 year. Under normal

battery conditions the Transmit LED on the Remote

Control will only illuminate when a button is pressed.

However, under low-battery conditions this LED will

continue to flash after the button has been released.

When this occurs the battery should be replaced as

soon as possible.

CONFIGURING THE REMOTE CONTROL

1. Remove the rear cover by using a small coin to

lever open the cover, see diagram above.

2. Insert the battery under the clip ensuring that

the

terminal faces upwards away from the

Circuit Board.

3. Replace the rear cover.

TESTING THE REMOTE CONTROL

4. Press the button. The Transmit LED

should illuminate while the button is pressed and

extinguish within 1 second of releasing the button.

5. Pressing any button on the Remote Control will

illuminate the Transmit LED as before to check

that it is functioning correctly.

CONTROL PANEL

POSITIONING THE CONTROL PANEL

When choosing a suitable location for the Control

Panel, the following points should be considered.

1. The Control Panel should be located in a

position out of sight of potential intruders and in

a safe location, but easily accessible for system

operation and leaving and entering the house

within the set time period.

2. The Control Panel should be mounted on a sound

flat surface to ensure that the rear tamper switch

on the Control Panel is closed when the Panel is

ZONE 1

NTER

ZONE 2 ZONE 3 ZONE 4

AMPERFIREZONE 6ZONE 5

OWER PART ARM ARM LOW BATT.

Zone

Indicator

LEDs

Status

Indicator

LEDs

Keypad

Transmit LED

Personal Attack Button

Press and hold for

3 seconds

Instant-Arm

isarm

elay-Arm

Battery Clip

Battery

Insert a small coin into the

slot on the edge of the

housing to gently lever open

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comentarios a estos manuales

Sin comentarios

Response SL8 Manual de instrucciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL8