Response SL8 Manual de instrucciones descargar pdf (Pagina 20)

4. DIP switch 1 marked “ALARM TIME” is used to

limit the maximum period for which the external

siren will sound before it will be automatically shut

down, (even if the Control Panel is still in alarm):

ON 10 minutes

OFF 3 minutes

5. DIP switch 2 marked “AJ” does not function for

this system and should be ignored.

6. DIP switch 3 marked “ALARM SOUND” if OFF

will prevent the siren from sounding during an

alarm, (this will not affect the warning beeps):

ON Siren enabled

OFF Siren disabled

7. Switching between Service Mode and Operating

Mode generates a series of beeps. It is possible

to disable these acknowledgement beeps with

DIP switch 4 marked “BEEP SOUND”.

ON Beeps enabled

OFF Beeps disabled

8. Now see Power-Up of the Solar Siren.

POWER-UP OF THE SOLAR SIREN

Note: The use of ear defenders is advisable when

working in close proximity to the Siren due to the high

sound level produced by this device when triggered.

Whenever the Siren is powered-up, it will automatically

power-up in Service Mode. It cannot be switched out

of Service Mode and into Operating Mode until the

Control Panel is linked to it.

9. Connect the rechargeable battery to the battery

leads. Connect the Red lead to the Red (+ve)

terminal and the Black lead to the Black (

ve)

terminal.

Connect the 9V 6LR61 (PP3) power-up battery

to the battery clip.

10. Press the tamper switch, both indicator LEDs will

flash together several times. The LEDs will then

continue to flash alternately every 5 seconds

thereafter to indicate that the Siren is functioning

(still in Service Mode).

11. If fitted remove the protective film covering the

Solar Panel.

12. Now follow the instructions on the next page to

Link the Solar Siren to the Control Panel.

Siren

7.5 Volt DC

charging

adaptor input

ALARM TIME

A J

C.U. OR SIREN

ALARM SOUND

BEEP SOUND

Learn

LED

2 3 4 5

ALARM TIME

ALARM SOUND

EEP SOUND

C.U. OR SIREN

2345

ALARM TIME

ALARM SOUND

BEEP SOUND

C.U. OR SIREN

Tamper

Switch

Learn

Switch

Switch SW3

9 Volt startup

battery

6 Volt 1.2Ah

rechargeable

battery

Wall mounting plate

IMPORTANT: Once the batteries have been

connected, the Siren will be operational and it is

important that the solar panel receives sufficient

light to maintain the battery charge. The Siren

should not be operated repeatedly during

installation and testing, as this will rapidly drain

the battery. It is recommended that the Siren be

left for at least a day in order to charge the

battery before the system is Armed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comentarios a estos manuales

Sin comentarios

Response SL8 Manual de instrucciones Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL8