Response SA5 E Instrucciones de operaciones descargar pdf (Pagina 38)

Dial up the system and hang up after two

rings.

. Redial up the system within 30s, the system

will pickup the phone after 1 ring.

. Enter the User Access code as normal.

The following functions may be access via the

remote. The system will acknowledge each signal

ith a single long beep.

Press to initiate ARM.

Press to initiate Part-Arm 1.

Press to initiate Part-Arm 2.

Press to Disarm the system.

Press to turn the Siren OFF.

Press to turn the Siren ON.

Press to Listen-In via the Control Panel

Microphone.

Press to stop Listen-In

Note: Listen-In will be automatically cancelled

after 5 minutes if not cancelled manually.

Press to interrogate the system Status. The

status tone will be repeated at 2s intervals for 15

seconds.

One beep ARM

Two beeps Part-Arm (1 or 2)

Three beeps Alarm triggered

One long beep Disarmed

Press to replay Answer-Phone messages.

While replaying a message, press for

2 seconds to skip to the end of the message

and hear the next message.

Press

to delete all Answer Phone messages.

Press to end the session and Hang up the

Control Panel line.

Battery Monitoring

All system devices continuously monitor their battery

ondition. The Control Panel also monitors the battery

condition of all PIR and Magnetic Detectors. If the

battery level of any device drops below acceptable

evels then its low battery indication will be activated.

In addition if any PIR or Magnetic Contact Detector

has a low battery status it will be indicated on the

‘

LOW BAT’ LED on the Control Panel.

LED Glowing Magnetic Contact

LED Flashing PIR

When a low battery indicator is activated the device

will continue to operate normally for up to 2 weeks

(depending on system use). However, the battery for

that device should be replaced as soon as possible.

Note: Before removing the battery cover on any device

to replace the battery, ensure that the system is put

into Test mode to avoid initiating a Full Alarm condition.

The low battery indication for each system component

is as follows:

Remote Control:

When the Remote Control is operated under low

battery conditions the transmit LED will continue to

flash after the button has been released.

Under normal battery conditions the LED will extinguish

when the button is released.

PIR Movement Detector:

Under low battery conditions the LED behind the

Detector lens will flash when movement is detected to

indicate that the battery needs to be replaced.

Under normal battery conditions the LED does not

illuminate unless the PIR Detector is in Walk Test mode.

Magnetic Contact Detector:

Under low battery conditions, when the Detector is

activated, the transmit LED will be illuminated for

approximately 1 second as the door/window is

opened.

Under normal battery conditions the LED will not

illuminate as the Detector is operated, (unless the

Detector is in Test Mode with the battery cover

removed).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios

Response SA5 E Instrucciones de operaciones Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SA5 E