Response SL2 Instrucciones de operaciones descargar pdf (Pagina 7)

REMOTE CONTROL UNIT

(Included in SL1 kit / optional

accessory for SL2 kit)

The Remote Control Unit(s) is used to Arm in either

Instant-Arm or Delay-Arm modes and to Disarm the

system.

The Remote Control Unit also incorporates a Personal

Attack (PA) switch. Activating the PA switch on the

side of the Remote Control will immediately trigger an

Alarm even if the system is disarmed (unless the Siren

is in Service Mode). The alarm can be cancelled by

pressing the ’DISARM’ button on the Remote Control.

Up to a total of 6 Remote Controls and/or Keypad Units

can be used with your system, providing they are all

operated within effective radio range of the Siren.

The Remote Control is powered by a CR2032 type

Lithium cell which under normal conditions will have an

expected life of approximately 1 year. Under normal

battery conditions the Transmit LED on the Remote

Control will only illuminate when a button is pressed.

However, under low-battery conditions this LED will

continue to flash after the button has been released.

When this occurs the battery should be replaced as

soon as possible.

CONFIGURING THE REMOTE CONTROL

1. Remove the rear cover by undoing the small

screw on the rear of the Remote Control and

keeping it safe for later.

2. Insert the battery under the clip ensuring that

the

terminal faces upwards away from the

Circuit Board.

3. Replace the rear cover and fixing screw. Do not

over tighten the screw as this could damage the

thread.

TESTING THE REMOTE CONTROL

4. Press the button. The Transmit LED

should illuminate while the button is pressed and

extinguish within 1 second of releasing the button.

5. Pressing any button on the Remote Control will

illuminate the Transmit LED as before to check

that it is functioning correctly.

6. In order to communicate with the Siren, the ID

code of the Remote Control needs to be learned

by the Siren, subject to the Siren Unit being

installed and configured if it is being set-up for

the first time (see pages 10 - 12).

KEYPAD

(Included in SL2 kit / optional

accessory for SL1 kit)

The Keypad is used to control the Siren and to Arm

and Disarm the system by entering a 4 digit User

Access Code. The Keypad can arm the system in

either Instant or Delay modes.

The Keypad incorporates a tamper protection facility.

Any attempt to open the casing of the Keypad will

immediately trigger an alarm even if the system is

disarmed, (unless the system is in Service Mode).

In addition if a sequence of more than 16 incorrect

key presses is entered the Keypad will be disabled

for the next 1 minute, (except for the tamper

protection function). If the Keypad is disabled three

times consecutively a ‘Tamper signal’ will be triggered.

Up to a total of 6 Keypad Units and/or Remote Controls

can be used with your system, providing they are all

operated within effective radio range of the Siren.

The Keypad also incorporates a Personal Attack (PA)

facility which will immediately trigger an alarm when

activated, (unless the Siren is in Service Mode).

Slide up

to operate

Transmit LED

Personal Attack

Switch

Instant-Arm

Delay-Arm

Disarm

Battery Clip

Battery

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentarios a estos manuales

Sin comentarios

Response SL2 Instrucciones de operaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Response SL2